In Cons of using a manual flash on camera, one of the replies suggests that it's not possible to use rear curtain sync.
However, as I understood it, rear curtain sync is basically when the flash gets triggered, and there shouldn't be a lot of communication required between the camera and the flash.
So is it possible to use a manual flash for rear curtain sync? If it helps, I'm considering one for Olympus OM-D EM10 Mark 2.
Answer
You are correct, rear curtain sync is a very old technique that long predates modern flashes and will not be hampered just because you're using a manual flash.
That being said, though most are, not ALL manual flashes are well suited for performing a rear curtain sync. Because the camera fires the strobes just before it closes the curtain, the electronic lag plus the strobe duration need to be short enough to complete before the curtain starts to close. Some flashes on the lower end of the cost spectrum might not be up to the task.
EDIT
Based on Michael Clark's comment below, I did a little additional research. I use mostly Nikon gear, which uses the center pin (or sync cable) to fire the rear curtain sync and so was not aware of this. Apparently Canon equipment uses a digital signal and as such won't work with a manual flash (or with wired studio strobes, which boggles my mind).
My basic advice will remain the same though, a manual flash does not automatically preclude rear curtain sync, but not all equipment is compatible, so always check the manuals and, if possible, test the equipment before you buy.
No comments:
Post a Comment